Vector VEC031POB Uživatelský manuál

1VEC031POBOWNER’S MANUAL& WARRANTY INFORMATIONTHIS MANUAL CONTAINS IMPORTANT INFORMATION REGARDINGSAFETY, OPERATION, MAINTENANCE AND STORAGE OF TH

10wattage rating. Induction motors, as well as some televisions, mayrequire 2 to 6 times their wattage rating to start up. The most demand-ing in thi

11Over Voltage Protection - The Power-On-Board™ 400 willautomatically shut down when the input voltage exceeds 15 volts DC.Short Circuit Protection -

12Television Interference:The Vector Power-On-Board™ 400 is shielded to minimize interferencewith TV signals. However, in some instances, some interfe

13TABLE 1 - INVERTER POWER SWITCH TURNED ON CON’TTROUBLE/INDICATION POSSIBLE CAUSE SUGGESTED REMEDYMotorized power tool Purely inductive load Make the

14120 DAY/2 YEAR LIMITED WARRANTY PROGRAMThis limited warranty program is the only one that applies to this product,and it sets forth all the responsi

15If your problem is not covered by this warranty, call our Technical SupportDepartment at (954) 584-4446 for general repair information and chargesif

16© 2001 VECTOR MANUFACTURING, LTD.FT. LAUDERDALE, FL 33312 MADE IN CHINA

2IMPORTANT INFORMATIONTo ensure reliable service, your power inverter must be installed andused properly. Please read the installation and operating

3CONTENTS1. INTRODUCTION ... 42. How Your Vector Inverter Works ...

41. INTRODUCTIONYour new Vector® Power-On-Board™ 400 inverter is one in a series ofthe most advanced DC to AC inverters available today. With properca

5FIGURE 1Principle of Operation2.2 THE POWER-ON-BOARD™ 400 OUTPUT WAVEFORMThe AC output waveform of the Power-On-Board™ 400 is known as"modified

63. INSTALLATION3.1 POWER SOURCE REQUIREMENTSThe power source must provide between 11 and 14.5 volts DC and mustbe able to supply the necessary curren

7CAUTION: Reverse polarity connection will result in a blown fuse andmay cause permanent damage to the inverter.Connecting to a Power Source Using Pro

88.Insert a 40 Amp fuse in the fuse holder.9.Test the inverter by turning it on and plugging in a 100 watt lampor equipment.10.If the inverter is not

93.5 PLACEMENT OF THE INVERTERFor best operating results, the inverter should be placed on a flat sur-face, such as the ground, car floor or seat, or