Vector JUMP-START SYSTEM Uživatelský manuál

OWNER’S MANUAL AND WARRANTY INFORMATIONTHIS MANUAL CONTAINS IMPORTANT INFORMATION REGARDING SAFETY,OPERATION, MAINTENANCE AND STORAGE OF THIS PRODUCT.

Try charging another battery, if the FAULT LED does not light, then one of the aboveproblems exists with the initial battery. Charger will not charge

CHARGER CONTROLS AND INDICATORSFigure 3 shows the charger control panel of the Jump ‘n Charge system, andconsists of:Digital Display - Displays FFUULL

11ALWAYS RECYCLEPRBAPRBAWARNING• Do not dispose of the battery in fire as this may result in an explosion• Before disposing of the battery, protect ex

READ AND OBSERVE ALL CAUTIONS AND WARNINGSSTEP-BY-STEP JUMP-STARTING INSTRUCTIONSThis Jump ‘n Charge system is equipped with an automatic ON/OFF funct

13WARNING:•Always disconnect the engine or frame jumper clamp first; followed by the batteryjumper clamp.•There is a risk of explosive gases being rel

14OPERATION AS A 12 VOLT DC PORTABLE POWER SUPPLYThe 12 volt DC outlet provides 15 amps maximum current for 12 volt DC operat-ed appliances.1. Lift up

152 YEAR LIMITED WARRANTY PROGRAMThis limited warranty program is the only one that applies to this product, and it sets forth all theresponsibilities

1IMPORTANT SAFETY INSTRUCTIONSWARNING - RISK OF EXPLOSIVE GASES1. WORKING IN VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS. BATTERIESGENERATE EXPLOSIVE

27. Do not disassemble charger; take it to a qualified service technician when serv-ice or repair is required. Incorrect reassembly may result in a ri

AC POWER CORD CONNECTIONThis charger is equipped for use with an extension cord. The extension cord must befirst connected to the charger’s polarized

SMART BATTERY CHARGERThe charger portion of the system is microprocessor-based and has three charge rate set-tings, controlled by one switch. (See Fig

5PREPARING TO CHARGE1. Determine voltage of battery by referring to car owner's manual.2. If it is necessary to remove battery from vehicle to ch

65. For negative grounded vehicle, connect POSITIVE (RED) clamp from batterycharger to POSITIVE (POS, P, +) post of battery. Connect NEGATIVE (BLACK)c

75. Carefully connect Negative (BLACK) charger clamp to the free end of the bat-tery cable connected to the negative terminal. Connect the charger&apo

8CHARGING TIMESThe Charger will automatically adjust the charge rate as the battery charges and stopscharging when the battery is fully charged. If yo