Vector VEC1086 A Uživatelský manuál stáhnout pdf

SMART AUTOMATIC

BATTERY CHARGER

12 VOLT 2/4/6 AMP CHARGE RATES

OWNER’S MANUAL & WARRANTY INFORMATION

• IMPORTANT SAFETY INSTRUCTIONS •

WARNING – RISK OF EXPLOSIVE GASES

WORKING IN VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS.

BATTERIES GENERATE EXPLOSIVE GASES DURING NORMAL BATTERY

OPERATION. FOR THIS REASON, IT IS OF UTMOST IMPORTANCE THAT EACH

TIME BEFORE USING YOUR CHARGER, YOU READ THIS MANUAL AND

FOLLOW THE INSTRUCTIONS EXACTLY.

2. To reduce risk of battery explosion, follow these instructions and those published by the battery

manufacturer and manufacturer of any equipment you intend to use in vicinity of battery. Review

cautionary markings on these products and on engine.

GENERAL BATTERY SAFETY

1. Use this charger for charging a LEAD-ACID battery only. It is not intended to supply power to a low voltage

electrical system other than in automotive applications. Do not use this battery charger for other types of batteries,

these may burst and cause injury to persons and damage to property.

2. Use of an attachment not recommended or sold by the battery charger manufacturer may result in a risk of fire,

electric shock, or injury to persons.

3. To reduce risk of damage to electric plug and cord, pull by plug rather than cord when disconnecting charger.

4. An extension cord should not be used unless absolutely necessary. Use of an improper extension cord could result

in a risk of fire and electric shock.

If extension cord must be used, make sure:

a. That pins on plug of extension cord are the same number, size, and shape as those of plug on charger.

b. That extension cord is properly wired and in good electrical condition; and

c. That wire size is AWG #16 (16 gauge) to 100 feet and AWG #14 for distances over 100 feet.

5. Do not operate charger with damaged cord or plug - replace immediately.

6. Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way; take

it to a qualified service technician.

7. Do not disassemble charger; take it to a qualified service technician when service or repair is required. Incorrect

reassembly may result in a risk of electric shock or fire.

8. To reduce risk of electric shock, unplug charger from outlet before attempting any maintenance or cleaning. Turning

off controls will not reduce this risk.

9. Do not expose charger to rain, snow or use when wet.

10 . Never charge a frozen battery.

SAVE THESE INSTRUCTIONS:

This manual contains important safety and operating instructions for battery charger Model VEC1086 A

4140 SW 28TH WAY, FT. LAUDERDALE, FL 33312 • TEL: 954-584-4446 • FAX: 954-584-5556 • TOLL-FREE 866-584-5504

VEC1086 A

California Proposition 65:

WARNING:

THIS PRODUCT CONTAINS CHEMICALS KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER OR REPRODUCTIVE TOXICITY

This device complies with Part 15 of the FCC Rules.

1 2 3 4 5 6 7 8 9 10

Shrnutí obsahu

Strany 1 - SAVE THESE INSTRUCTIONS:

SMART AUTOMATICBATTERY CHARGER12 VOLT 2/4/6 AMP CHARGE RATES OWNER’S MANUAL & WARRANTY INFORMATION• IMPORTANT SAFETY INSTRUCTIONS •WARNING – RISK

Strany 2 - AC POWER CORD CONNECTION

VEC1086 AREV10110310VECTOR 5 YEAR LIMITED WARRANTY PROGRAMThis limited warranty program is the only one that applies to this product, and it sets fort

Strany 3 - DC CONNECTION PRECAUTIONS

VEC1086 AREV1011032PERSONAL PRECAUTIONS AND SAFETY1. Another person should be within range of your voice or close enough to come to your aid when you

Strany 4 - FEATURES

VEC1086 AREV1011033PREPARING TO CHARGE1. Determine voltage of battery by referring to car owner's manual.2. If it is necessary to remove battery

Strany 5 - CONTROLS AND INDICATORS

INTRODUCTION AND FEATURESThank you for selecting the Vector® Model VEC1086 A, 2/4/6 Amp 12 volt Smart Battery Charger. With proper care and use,it wil

Strany 6

VEC1086 AREV1011035FIGURE 2A FIGURE 2BCONTROLS AND INDICATORSThere are four (4) LED indicators and one button switch (select charge rate) that make up

Strany 7 - CARE AND MAINTENANCE

6CHARGING IF BATTERY IS INSTALLED IN A VEHICLEa) Check polarity of battery posts - For top-mounted battery posts, the Positive post (marked POS, P, +)

Strany 8

VEC1086 AREV1011037CHARGING IF BATTERY IS OUTSIDE OF VEHICLEa) Check polarity of battery posts- For top-mounted battery posts, the positive post (mark

Strany 9 - APPENDIX A - CHARGING TIMES

VEC1086 AREV1011038TROUBLESHOOTING – FAULT LED LITNOTE: Charger will NOT operate on batteries below 4.0 Volts. If a 12 Volt battery is below 4.0 Volts

Strany 10 - VEC1086 A

VEC1086 AREV1011039APPENDIX A - CHARGING TIMESTo calculate the approximate charging time required to fully charge a battery, it is necessary to deter

Komentáře k této Příručce

Žádné komentáře

Vector VEC1086 A Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Nabíječky baterií Vector VEC1086 A. Vector VEC1086 A Owner`s manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro Nabíječky baterií Vector VEC1086 A